 |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
 |
 |
 |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Links
|
Honda CT90 Tech Help
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| Part Name | Model or Year | Where to Buy | More About this Part… |
| Unifilter BF-1 Bulk Air Filter Foam | Later CT-90s and probably CT-110s. I used on a 1975. | AZ Motorsports, MotorHelmets, RepairManual | 2 filters from 1 pkg if you are careful. Cut and form tube using silicone seal. |
| Part Name | Model or Year | Where to Buy | Substitute Part |
| Tail-light | All 6Volt | Canadian Tire | MotoMaster part no. 20-2628-8 |
| Part Name | Model or Year | OEM? | Where to Buy | More About this Part… |
| Muffler rust hole fix | Any | JB Weld | Almost any Home Center | Lightly sand the area around the rust hole. If hole is larger than 1/2 ” in diameter , put scotch tape over hole. Be sure sanded area extends past the tape. Mix JB Weld and use a large tounge depresser (or similar) to spread the JB Weld over the area of the tape and on to the sanded area. |
| Part Name | Model or Year | Where to Buy | More About this Part… |
| Kopr-Shield | Any | Eastwood Co. | This is a copper-based contact paste used to reduce electrical resistance and cortrosion, and is helpful on CT90 bullet connectors and such. Vic Barkas |
| Part Name | Model or Year | Where to Buy | Substitute Part | More About this Part… |
| Jasco Metal Etch (fuel tank cleaning) | Any | Most hareware stores (Paint dept.) Cheap! | Contains phosphoric acid, same as Naval Jelly | Use undilluted quart in tank, leave 24hrs, aggitating & turning tank several times. Save and reuse. Rinse tank out with gasoline. |
| Part Name | Model or Year | More About this Part… |
| Headlight bucket | ct200, c200 and ct90K0 | The plastic headlight bucket that goes over the front fender is the same on these three bikes. |
| Part Name | Model or Year | Where to Buy | Substitute Part | More About this Part… |
| Fibre Washer for under carb top cap | CT90 | Home Depot, Lowes, Rona or hardware store in specity item area in screw dept. | Manufactured by Lincoln Products – Industry, CA 91748 – Part # 129390 | Fibre Wash 3/4 x 5/8 x 1/32 – comes in plastic envelope measuring 3 x 3 inch. |
| Part Name | Model or Year | Honda Part # | OEM? | More About this Part… |
| Carby Cleaner | All | Yamaha Part #AAA-CARBC-LE-NR | Yes | May be diluted with gasoline or distilled water, see container. |
| Part Name | Model or Year | Honda Part # | OEM? | Where to Buy | More About this Part… |
| Carburetor Kit | CT90 K0 | Keyster #KH-0202N (Original number 16100-053-305/315) | NO discontinued through dealer. DrAtv doesn’t have them either | Sirius | This is the one that everyone said is discontinued. Sirius worked with the manufacturer to get the right kit and gasket. Fits CT90 K0 122551-188271 and has the correct gasket too. |
| Part Name | Model or Year | Honda Part # | OEM? | Where to Buy | More About this Part… |
| Carb Kit (Honda) | CT90 K1 from Ser. # 234852 thru CT90 – 1977 | 16010-102-004: CT90 K1 fm # 234852 thru K3# 426465: 16010-102-305: K1 fm # 234852 thru CT90 – 1977 | 16010-102-305 current stock item thru Honda dealers | Try Western Honda – good discount 1-800-279-RIDE | Flat bowl gasket, O rings, fuel cock gasket etc. |
| Part Name | Model or Year | Honda Part # | OEM? | More About this Part… |
| Carb Kit (Honda) | CT90 K1 up to serial # 234851 | 16010-077-305 | Honda dealers or Western Honda 1-800-279-ride – good discount | Has round o ring for float bowl seal, 4 hole fuel cock gasket and other o rings |
| Part Name | Where to Buy | Substitute Part | More About this Part… |
| CT90 K0 exhaust | dratv.com | Dr. ATV K2+ exhaust ($109) | All that needs modified is the mounting bolt that goes through to the gas tank. I replaced the mounting bolt with a longer M6 bolt and made a sleeve to space the exhaust out. |
| Part Name | Model or Year | OEM? | Where to Buy | Substitute Part |
| Bridge Rectifier | all | no | Radio Shack or The Source | Radio Shack part number 276-1185, full wave bridge rectifier, about 1″ square in size with 4 terminals. Cost $2.98 and works much better then the stock honda rectifier which is much more expensive. |
 | US $24.99 End Date: Thursday Aug-28-2014 2:18:04 PDT Buy It Now for only: US $24.99 Buy it now | Add to watch list |